Potential causes of dirty electricity and electropollution

• Solar panels

• Inside wiring errors

• Computers and laptops

• Variable speed motors

• Televisions

• Entertainment units

• Energy efficient lighting

• Energy efficient appliances

• SMART Meters Dimmer switches

• Fluorescent light bulbs and tubes

• Power tools

• Cell phone antennas

• Broadcast antennas

• Solar Power panels

• Cordless phone systems

• Video game consoles

• Wi-Fi routers and modems

• Microwave Ovens

• Kitchen appliances

• Hair Dryers

• Dirty Electricity Meter

• Works for 60 Hz/120 Volt North American and 50 Hz/240 A.C. Volt European systems.

• LCD display reads the Volts per second present, which is an approximation for the high frequency energy. High frequencies are the frequencies which are most harmful to equipment, animals, and humans.

• Is simple to use — just plug the meter into any standard electrical outlet.

• Conveniently lists the good, marginal, and undesirable range of meter readings on the back of the Microsurge Meter.

Electrosensitive people have reported sensitivities with readings as low as 27 on the Microsurge meter. However, medium or even low Microsurge Meter readings should not be interpreted as a guarantee that there is no harmful health impact; only a medical expert can determine that. Caution is required. Some harmful health effects of high frequency energy on humans appear to be cumulative, and possibly non-reversible. Science is inconclusive in this area, although the body of empirical evidence available for guidance continues to expand and stabilize.

Using Meter

Test your outlets to see what the levels are in volts per meters. Then plug in the filter to see if it goes down below 50. Microsurge meters measure the levels of safe, borderline, or dangerous levels of “energy” present. These levels are conveniently shown on the back of the meter for reference.

Starting from points that typically have the highest readings such as the power input panel, computers, and televisions, the meter is used to measure the initial levels of GS energy, and its reduction as filters are added. Once the GS levels are acceptable at one location, the process should be repeated at the next location. After the installation of the filters is complete, a final confirmation of the GS levels should be performed throughout the house.

Model:GS-M300-AColor:WhiteLength (in.):4.25Width (in.):2.75Height (in.):1.00Input:110V/240V, 50/60 Hz;Plug Type:Type A (ungrounded)Cord Length (in.):36For Use In:North, Central, and South America, and the Caribbean

Read more about Dirty Electricity here on our blog: https://www.designwellstudios.com/blog/2023/12/21/volafh7hcgj746sybkaolsnxfdwj45